PULSE (tremolo) module

The PULSE module adds an auto volume swelling effects, and at higher settings gets a bit of saturation and modulation.

At 0%, the signal is clean. At 100%, the signal has a deep volume swell at fast speeds with a bit of twisting modulation.

Figure 476. PULSE module.

A. Clipping LD B. PULSE enable/disable C. PULSE 

The PULSE module contains the following controls:

Clipping LED. Shows if the input signal to the PULSE module is clipping. If there is any distortion in the ProChannel signal chain, the clipping LEDs let you identify where the clipping occurs.

PULSE enable/disable . Enables/disables the PULSE module.

PULSE. Adjusts the amount of volume swell and modulation. At 0%, the signal is clean. At 100%, the signal has a deep volume swell at fast speeds with a bit of twisting modulation.

 

See:

ProChannel

Using ProChannel

ProChannel modules and controls

PC76 U-Type Channel Compressor module

PC4K S-Type Bus Compressor module

QuadCurve Equalizer module

Tube Saturation module

PC2A T-Type Leveling Amplifier

Softube Saturation Knob

Console Emulator module

FX Chain module

Tape Emulator module

REmatrix Solo convolution reverb

Concrete Limiter module

GRIT (saturation) module

MAX (volume maximizer) module

SPACE (reverb/ambience) module

SMOOTHER (de-esser / de-harsher) module

GATER (remove noise) module

DEPTH (chorus / stereo shaping) module

SHAPER (transient control) module