Choosing the instrument sound (bank and patch)

Electronic keyboards and synthesizers often contain hundreds or thousands of different sounds. Each sound is known as a patch. The name comes from the early days of synthesizers, for which you physically rewired (using patch cords) the oscillators and modulators to produce different sounds. Patches are normally organized into groups of 128, called banks. Most instruments have between 1 and 8 banks, but MIDI supports up to 16,384 banks of 128 patches each (that’s over 2 million patches).The Bank and Patch controls in the Console view and Track Inspector control the initial bank and patch of a track during playback. Every time Music Creator starts playback at the beginning of a project, the bank and patch settings for the track are set to these initial values. Many instruments have descriptive names for their banks and patches. Music Creator stores these names in an instrument definition. If you are using an instrument that supports General MIDI, your patch list will contain the 128 sounds that are defined by the General MIDI specification.

Note: Different MIDI instruments use different types of commands to change banks. Music Creator supports four common methods for changing banks. For information about the bank selection method you should use with your MIDI gear, see your MIDI equipment’s documentation.

Tip: If your bank name is too long to fit in the Bank field, hold your cursor over the bank name. A tooltip appears with the complete bank name.

Note that a single MIDI channel can only play one patch at a time on each instrument assigned to that channel. Therefore, if two or more MIDI tracks are set to the same output and channel but have different bank and patch settings, the patch of the highest-numbered track will be used for all the tracks. In some projects you want the sound played by a track to change while playback is in progress. When you start playback in the middle of a project, Music Creator searches back through the track to find the correct patch to use—either the initial bank and patch or the most recent bank/patch change. Note that the Console view and Track Inspector only show the initial bank and patch, even while a different bank and patch are being played back. The only way to see and edit a bank/patch change is in the Event List view. For more information, see The Event List view.

To assign an initial bank and patch to a track

1.	Open the Track Inspector or Console view and select the MIDI track you want to configure.

2.	Select the desired settings in the Bank and Patch controls.

3.	To search for a patch containing specific text, click the Patch Browser button in the Track Inspector. You can also open the Patch Browser by right-clicking a bank or patch control in the Track Inspector or Console views.

To choose patches with the Patch browser

1.	Do one of the following:

In the Track Inspector or Console view, right-click the patch name in the track module you want to change patches in.

In the Track Inspector, click the Patch Browser button in the track you want to change patches in.

The Patch browser dialog box appears, displaying a list of all the Instrument patch names that have been installed.

2.	Search for a patch name, if desired, by filling in text in the Search field at the top of the dialog box.

3.	When you find the right patch, click its name and click OK.

Music Creator changes the patch of the track you selected.

 

See:

Patch Browser dialog